System Test; Installer Setup - homexpert THR870CUK User Manual

Installation and Setup

System test

Press OFF, check heating After installation, you should check to make sure the system is
working properly.
Thu 30/12/10
1 Press the thermostat OFF button, then verify that the heating
23.
°
12:34
system is on.
PM
5
Room Temp
2 Press the thermostat MAN button, then press the p button to
raise target temperature to maximum (35°C).
AUTO MAN OFF
If the system is set up properly, the "heating" symbol should
Press MAN, set temperature to 35°C
appear on the thermostat display, and the heating system should
begin running after a short delay.
Thu 30/12/10
3 To stop the test, press AUTO to run the program schedule, or
35.
°
12:34
PM MAN to reset the temperature manually.
0
TARGET TEMP
AUTO MAN OFF
Make sure heating symbol appears
Thu 30/12/10
35.
°
12:34
PM 0
26

Installer setup

Installer settings allow you to customise how your system
Thu 30/12/10
works. Check the tables on pages 28-31 to see if any settings
23.
need to be changed.
°
12:34
PM 5
Room Temp To change installer settings:
1 Press the thermostat OFF button.
AUTO MAN OFF
Press and hold to enter installer mode 2 Press and hold the i, < and > buttons until the screen
3 Press the + or - buttons to scroll through functions quickly
4 Press the p or q buttons to change any setting, then
12
1:CL
CLOCK SELECT
1 2
Press to scroll Press to change
through functions setting
See tables on pages 28-31 for
complete list of functions and settings
homexpert by Honeywell THR870CUK Programmable Thermostat
tm
changes.
until you find one you want to change.
press OK to save the new setting.
To exit installer setup, press any MODE button (Auto,
Manual or Off).
27