How To Set Remote Control Selector Switch - Toshiba RAS-18UFHP-ES Service Manual

8-6. How to Set Remote Control Selector
Switch
When two indoor units ae installed in seperated rooms,
there is no need to change the selector switch.
<Remote control selector switch>
• When two indoor units are installed in the same
room or the adjacent two rooms, they may be
controlled simultaneously with a single remote
control. To prevent this, set either unit and its remote
control to B setting. (Both units are set to A setting
before shipment.)
• The remote control signal is not recived when the
indoor unit setting is different from the remote
control one.
1. Set the remote control selector switch with the
indoor unit.
1) Turn the circuit breaker of the main power switch off
before setting the selector switch.
2) Remove the Air inlet grille. (Refer to page 35, 8-4-2)
Fig. 8-6-1
3) Select the terminal of selector switch from [A
position] to [B position].
Fig. 8-6-2
2. Set the remote control selector switch with the
remote control
[B] is indicated on the liquid crystal display when
setting remote control selector switch to B. [A] is not
indicated on the display even if the selector switch
is set to A.
1) Load the remote control with the batteries.
2) Press the [CHECK] button using something with
sharp point. (The preset temperature on the remote
control changes to [00].)
3) Press the [MODE] button while pressing the
[CHECK] button, [B] is indicted at the right of the
present temperature display.
• To reset the switch to the [A] setting, press the
[MODE] button again while pressing the [CHECK]
button.
A
B
START/STOP
FAN MODE
SWING ECO
TIMER
FIX
ON OFF
FILTER
RESET
3. Confirm that the indoor unit can operate with the
new setting.
– 44 –
FILE NO. SVM-02009
A
B
PRESET
AUTO
Hi-POWER
[MODE] button
MEMO
SET CLR
CLOCK CHECK
[CHECK] button
Fig. 8-6-3