Table of Contents
Advertisement
How to connect to a stereo system
Connect the LINE-2 IN L/R jacks on this DVD-VCR to the audio output jacks on the stereo
system, using an audio cable (not supplied).
Notes
• Make sure you connect the plugs to jacks of the same colour.
• If the other VCR is a monaural type, leave the red plugs unconnected.
• If you connect this VCR to both the LINE IN and LINE OUT jacks of the other VCR, select
the input correctly to prevent a humming noise.
• When you connect another VCR to the LINE-2 connector, press INPUT SELECT to display
"L2" in the display window.
Operation (when recording on this VCR)
Before you start editing
• Turn on your TV and set it to the video
channel.
• Press INPUT SELECT to display the
connected line in the display window.
• Press SP/LP to select the tape speed, SP or
LP.
• Press SELECT VIDEO to control the
VCR.
1
Insert a source tape with its safety tab removed into the other (playback)
VCR. Search for the point to start playback and set it to playback pause.
2
Insert a tape with its safety tab in place into this (recording) VCR. Search
for the point to start recording and press X to set it to playback pause.
3
Press
REC
4
To start editing, press the X (pause) buttons on both VCRs at the same time.
To stop editing
Press the x (stop) buttons on both VCRs.
Tip
• To cut out unwanted scenes while editing, press X on this VCR when an unwanted scene
begins. When it ends, press X again to resume recording.
REC on this VCR to set it to recording pause.
z
X x
z REC
97
Editing
Advertisement
Table of Contents
