Setting The Setup Menu - Zenith VRE4122 Installation And Operating Manual

SETTING THE SETUP MENU

MAIN MENU
CLOCK
PROGRAM
TUNING
SETUP
SELECT ENTER
TO EXIT PRESS
SETUP MENU
FUNCTION OSD : ON
LANGUAGE SELECT:ENGLISH
AUDIO MODE: HI-FI
BROADCAST TYPE: STEREO
AUDIO OUTPUT: STEREO
SELECT ADJUST
TO EXIT PRESS
D D E E
Press or to choose a
desired option on the
SETUP menu. Then press
F F or G G to choose a
desired setting.
16
FUNCTION OSD
The onscreen display of this VCR can be turned on or off.
Use the FUNCTION OSD option to select ON or OFF by press-
ing F F or G G .
LANGUAGE SELECT
The onscreen programming of this VCR can display in either
English, Spanish, or French.
Use the LANGUAGE SELECT option to select ENGLISH,
SPANISH, or FRENCH by pressing
AUDIO MODE DISPLAY
The VCR has two separate audio playback systems, the high quality
VHS Hi-Fi system and standard NORMAL mono system. The same
audio is generally recorded on both systems. The VHS Hi-Fi system
plays on separate (left and right) channels, and the NORMAL system
plays monaural sound. The normal track is always played so the cas-
sette can be played on a VCR that does not have VHS Hi-Fi.
Use the AUDIO MODE option to select HI-FI or NORMAL by
pressing F F or G G .
BROADCAST TYPE DISPLAY (STEREO/SAP/MONO)
Multichannel Television Sound (MTS) carries stereo and/or
Second Audio Program (SAP) bilingual signals. Set this display
to the desired position when both MTS stereo and SAP signals
are received. When only one of the MTS signal is received, the
VCR automatically selects the corresponding receiving mode
(Stereo or SAP) regardless of the selected position.
For normal operation, the display should be in the STEREO posi-
tion. The VCR will then record a STEREO program when available,
and record a mono program IF the program NOT IN STEREO.
Use the BROADCAST TYPE option to select STEREO, SAP,
or MONO by pressing F F
• For weak STEREO and/or SAP broadcasting, changing the
display to mono may give clearer sound.
AUDIO OUTPUT DISPLAY (STEREO/LEFT/RIGHT)
Used during playback [when AUDIO MODE display (HI-FI/NOR-
MAL) is in HI-FI position] for selecting the audio output signals from
the AUDIO OUT terminals (L ch and R ch), and VHF/UHF/CATV.
This display setting should normally be left in the stereo position,
so that when a stereo tape is played, the stereo sound will be
heard through the left and right channels. If a mono tape is
played and the audio output is set to stereo, the same mono
sound will be heard from both left and right channels.
Use the AUDIO OUTPUT option to select STEREO, LEFT, or
F F
RIGHT by pressing or
F F or G G .
or G G .
G G
.