Zanussi ZWG 580 P User Manual page 16

Extra Rinse
4h
4
8h
+
5
Start/Pause
6
Indicator pilot lights
7.1
7.2
7.3
At the end of the programme
The appliance stops automatically. The pilot
light of the button 6 and the pilot light corre-
sponding to the just finished washing phase go
off. The light 7.3 illuminates.
16
This appliance is designed for saving water. However, for people with
very delicate skin (allergic to detergents) it may be necessary to rinse
the laundry using an extra quantity of water.
Press simultaneously the buttons 4 and 5 for some seconds: the pilot
light 7.2 comes on. This function stays permanently on. To remove it
press the same buttons again until the pilot light 7.2 goes off.
Start the programme by pressing the button 6
• To start the selected programme, press the button 6, the corre-
sponding green pilot light stops flashing. The pilot light 7.1 illumi-
nates to indicate that the appliance starts operating and the door is
locked. If you have chosen a delayed start, the appliance will begin
the countdown.
• To interrupt a programme which is running, press the button 6:
the corresponding green pilot light starts flashing. It is possible to
change some options of a running programme before the pro-
gramme carries them out.
• To restart the programme from the point at which it was interrup-
ted, press the button 6.
• After the programme has started the door is locked. If, for any rea-
son, you need to open the door, set firstly the appliance to
PAUSE by pressing the button 6. After a few minutes it will be pos-
sible to open the door.
If the door remains locked, this means that the appliance is already
heating or that the water level is too high. In any case, do not try to
force the door!
If you cannot open the door but you need to open it you have to
switch the appliance off by turning the selector dial to
few minutes the door can be opened (pay attention to the water
level and temperature!). After closing the door, it is necessary to
select the programme and options again and to press the button 6.
• When you start the programme by pressing the button 6, the wash-
ing phase pilot light (7.1) illuminates. This means that the appliance
is operating.
• The additional rinses pilot light (7.2) illuminates when the appliance
perform an extra rinse.
• When the programme has finished the end cycle pilot light (7.3)
comes on.
If a programme or an option that ends with wa-
ter left in the tub has been selected and the
door remains locked to indicate that the water
must be emptied out before opening the door.
Follow the below instructions to empty out the
water:
. After a
www.zanussi.com