Tx Overload Indicator; Antenna; Belt Clip; Eng-1 Set-Up - Telex ENG-1 Operating Instructions Manual

TX Overload Indicator: A red LED displays when the modulation
(Audio Output) of the transmitter used is to high. Refer to the
"Audio/Gain Adjustment" of your transmitter for proper setting.
Antenna: A molded VHF antenna is supplied with the ENG-1. This
antenna is matched to the receiver frequency of your unit.
DO NOT Grip the antenna while attached to the ENG-1
case. Using the Antenna as a "Handle" may cause
damage to the ENG-1 Receiver.
Belt Clip: The belt clip can be removed for application of the supplied
"adhesive backed Velcro: for application to a camera or other
equipment.

ENG-1 Set-up

Power\Low Battery Indication: Install a fresh alkaline battery in the
ENG-1 receiver or connect the ENG-1 to any filtered 8-24 VDC source
via the DC jack on the side of the unit. Turn the receiver power on.
Note that the low battery (yellow) LED should flash on. If the battery
LED stays illumunated, this indicates a weak battery. If the battery
LED does not come on at all, the battery is dead.
CAUTION:
-7-