Displaying An Image; Adjusting The Image - InFocus IN72 User Manual

Displaying an image

Connect the power cord to the Power connector on the back of the projector
and to your electrical outlet.
NOTE: Always use the power cord that shipped with the projector.
Press the Power button on the remote or keypad.
The LED flashes green and the fans start to run. When the lamp comes on,
the start-up screen is displayed and the LED is steady green. It can take a
minute for the image to achieve full brightness.
? No start up screen? Get help on page 13.
Plug in, connect, and turn on your video device.
The video device's image should appear on the projection screen. If it
doesn't, press the Source button on the keypad until the image appears.
? No image? Try pressing the Auto Image button on the remote. Get
help on page 13.

Adjusting the image

Adjust the height of the image by tilting the projector up or down.
Position the projector the desired distance from the screen at a 90 degree
angle to the screen.
See page 5 for a table listing screen sizes and distances to the screen.
plug in Power cord
press Power button
turn on video device
adjust height
adjust distance
10