Kenwood KNA-G510 Instruction Manual page 56

•
• WARNING
Car fuse box
(main fuse)
Do not connect the yellow wire
lead directly to the vehicle battery.
Connecting directly to the battery
may cause the wire insulation to
fail and may pose a risk of short
circuit and electric shock.
Installing the GPS antenna
Best (roof of
vehicle)
Bette,
(truOk~d
(;"ide ""
of vehicle) = on dashboard)
o
0 -
4
To display unit (NAV IfF terminal)
GPS antenna
0
Black
To vehicle chassis
2A
Red
-+
To ignition (12 V)
Car fuse box
2A
Yellow
-+
To battery (12 V)
Steps to install the KNA-G510
1. Remove the key from the vehicle's ignition
and disconnect the negative battery cable.
2. Install the GPS antenna. Refer to the tips
on the previous page.
3. Connect the wiring harness to your vehicle
in the following order: ground, battery,
ignition.
4. Connect the wiring harness to the
main unit.
5. Install the main unit. Refer to the tips on the
previous page.
6. Reconnect the negative battery cable.
• CAUTION
If your vehicle's ignition does not have
an ACC position, connect the ignition
wires to a power source that can be
turned on and off with the ignition key. If
you connect the ignition wire to a power
source with a constant voltage supply,
as with battery wires, the vehicle's
battery may die.
Light green
To parking brake
detection switch
• WARNING
Be sure to connect the parking
brake wire to ensure safe
navigation.