Poulan Pro PP11H30ES Owner's Manual page 9

SPARK
PLUG
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
THROTTLE
/ ENGINE
CONTROL
RECOIL
POWER
(AUXILIARY)
CORD
STARTER
PLUG
HANDLE
PRIM ER
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AU GERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of
the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for start ing en gine.
Drift cutter - used to cut through deep snowdrifts.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Freewheel control – disengages transmission for pushing
the snowthrower with the engine off.
Choke control - used for starting a cold engine.
OPERATION
ENGINE OIL CAP
WITH DIPSTICK
OIL
DRAIN
PLUG
DISCHARGE
CHUTE
ELECTRIC
START
FUEL
BUTTON
SHUT-OFF
CLEAN-
VALVE
OUT
TOOL
AUGER
CONTROL
LEVER
DRIVE SPEED
CON TROL LEVER
GAS O LINE
FILLER
CAP
CHUTE
DE FLEC TOR
FIG. 10
LH and RH turn triggers - used to steer the snow thrower.
Throttle/engine control - used to se lect either FAST or
SLOW engine speed and to STOP the engine.
Traction drive control lever - used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di-
rec tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Defl ector remote control lever - used to change the
9 dis tance the snow is thrown.
DISCHARGE CHUTE CONTROL LEVER
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
LIGHT
HANDLE
KNOB
MUF FLER
TOOLBOX
FREEWHEEL
CONTROL
DRIFT CUTTER
SKID PLATE