Table of Contents
Advertisement
External Control Device Setup
Connect the RS-232C input jack to an external control device (such
as a computer or an A/V control system) and control the set's func-
tions externally.
RS-232C input socket
1. Connect the serial port of the control device to the RS-232C
jack on the set.
2. RS-232C connection cables are not supplied with the set.
3. The set's remote control handset and front panel controls
(except main power) will not be functional if the set is controlled
by a PC computer or other external device.
D-Sub 9-pin male
No.
Pin name
1
No connection
2
RXD (Receive data)
3
TXD (Transmit data)
4
DTR (DTE side ready)
5
GND
6
DSR (DCE side ready)
7
RTS (Ready to send)
8
CTS (Clear to send)
9
No Connection
Set ID
Use this function to specify a monitor ID number.
Refer to 'Real Data Mapping 1'. See page 41.
1. Press the MENU button and then use the
the SPECIAL menu.
G
2. Press the
button and then use
G
3. Press the
button and then use
to choose the desired monitor ID number.
Note : The adjustment range of
Communication Parameters
• Baud rate : 115200 bps (UART)
• Parity : None
• Communication code : ASCII code
Use a crossed (reverse) cable.
*
SPECIAL
Language
Child Lock
Orbiter
Set ID
Set ID
G G
1
MENU
Prev.
D
E
/
F
G
/
Set ID
is 1 ~ 99.
D
E
button to select
/
button to select
Set ID
button to adjust
Set ID
• Data length : 8 bits
• Stop bit : 1 bit
.
1
5
9
6
37
Advertisement
Table of Contents
