Rs-232 Host Parameters - Motorola DS3508 Product Reference Manual

7 - 4 DS3508 Product Reference Guide

RS-232 Host Parameters

Various RS-232 hosts use their own parameter default settings. Selecting standard, ICL, Fujitsu, Wincor-Nixdorf
Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, Omron or Common Use Terminal Equipment
(CUTE-LP/LG) sets the defaults listed in
Terminal Specific RS-232
Table 7-2
Parameter ICL
Transmit Code ID Yes
Data Data/Suffix
Transmission
Format
Suffix CR (1013)
Baud Rate 9600
Parity Even
Hardware RTS/CTS
Handshaking Option 3
Software None
Handshaking
Serial Response 9.9 Sec.
Time-out
Stop Bit Select One
ASCII Format 8-Bit
Beep On <BEL> Disable
RTS Line State High
Prefix None
*In the Nixdorf Mode B, if CTS is low, scanning is disabled. When CTS is high, scanning is
enabled.
** If you scan Nixdorf Mode B without connecting the digital scanner to the proper host, it
may appear unable to scan. If this happens, scan a different RS-232 host type within 5 seconds
of cycling power to the digital scanner.
The CUTE host disables all parameter scanning, including Set Defaults. If you inadvertently
select CUTE, scan *Enable Parameter Bar Code Scanning (01h) on page 4-6, then change the host
selection.
Table 7-2.
Wincor-
Fujitsu Nixdorf
Mode A
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
None Odd
None RTS/CTS
Option 3
None None
2 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low
None None
Wincor-
Nixdorf Mode Olivetti
B/OPOS/JPOS
Yes Yes
Data/Suffix Prefix/Data/
Suffix
CR (1013) ETX (1002)
9600 9600
Odd Even
RTS/CTS Option None
3
None Ack/Nak
9.9 Sec. 9.9 Sec.
One One
8-Bit 7-Bit
Disable Disable
Low = No data to Low
send
None STX (1003)
Omron CUTE
Yes Yes
Data/Suffix Prefix/Data/
Suffix
CR (1013) CR (1013)
ETX (1003)
9600 9600
None Even
None None
None None
9.9 Sec. 9.9 Sec.
One One
8-Bit 7-Bit
Disable Disable
High High
None STX (1002)