HP ProCurve 2810 Series Management And Configuration Manual page 395

4. Since the OS file is large, you can increase the speed of the download by
changing the switch console and terminal emulator baud rates to a high
speed. For example:
a. Change the switch baud rate to 115,200 Bps.
=> sp 115200
b. Change the terminal emulator baud rate to match the switch speed:
i. In HyperTerminal, select Call | Disconnect.
ii. Select File | Properties.
iii. Click on Configure . . ..
iv. Change the baud rate to 115200.
v. Click on [OK]
vi. Select Call | Connect
vii. Press [Enter] one or more times to display the => prompt.
5. Start the Console Download utility by typing do at the => prompt and
pressing [Enter]:
=> do
6. You will then see this prompt:
7. At the above prompt:
y
a. Type (for Yes)
b. Select Transfer | File in HyperTerminal.
c. Enter the appropriate filename and path for the OS image.
d. Select the Xmodem protocol (and not the 1k Xmodem protocol).
e. Click on [Send].
If you are using HyperTerminal, you will see a screen similar to the
following to indicate that the download is in progress:
. In the next window, click on
Troubleshooting
Restoring a Flash Image
[OK] again.
C-45