Removing A Diskette Drive; Installing A Diskette Drive - Dell PowerEdge 850 Installation And Troubleshooting Manual

4. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Diskette Drive

Removing a Diskette Drive

CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the
3. Lay the system on its right side.
4. Remove the cover. See "Removing the
5. Disconnect the power cable and the interface cable from the diskette drive. See Figure 7-2.
6. Remove the two screws that secure the diskette drive in the externally accessible drive bay. See Figure 7-2.
7. Slide the diskette drive forward out of the drive bay.

Installing a Diskette Drive

CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
1. Unpack the drive and prepare the drive for installation.
For instructions, see the documentation that accompanied the drive.
2. Slide the diskette drive into the externally accessible drive bay.
3. Install the two screws that secure the diskette drive in the drive bay. See Figure 7-2.
4. Connect the power cable and the interface cable to the diskette drive. See Figure 7-2.
5. Install the cover. See "Replacing the
6. Stand the system upright.
7. Install the bezel. See "Installing the
8. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 7-2. Removing or Installing a Diskette Drive
Bezel" in "Troubleshooting Your System."
Cover" in "Troubleshooting Your System."
Cover" in "Troubleshooting Your System."
Bezel" in "Troubleshooting Your System."