Amcor 9KE(H)-410 English Instruction Manual page 6

Setting the temperature
If you want to change the set temperature press
display will indicate the set temperature.
Note: Reaching the set temperature depends on the room and outdoor climatic conditions.
Mode switch
Press the button successively until the icon representing the desired mode is appearing
(=> Cool => Fan => Heat => etc). On the LCD-display you will see:
Cooling
Each time the unit starts, it starts operating in cool mode with a set temperature of 22°C. The
fan speed will be selected automatically. Heat mode is only available on EH models.
Fan speed
If you prefer a constant fan speed instead of the auto fan speed, press the
successively; the fan icon
• Fast - for the turbo speed
• Normal - for the medium speed
• Slow - for the slow speed
• Alternating - for the auto fan speed (in the cooling mode only!)
Switching LCD backlight ON/OFF
• If you prefer to switch the LCD backlight off, push the
time. After blinking twice the backlihgt will be switched off after 3 sec.
• By pushing any button on the control panel the backlight will s
Heat pump
With the mode switch select
unit this temperature is reached. Fan speed is selected automatically. Do not place
the unit near anything that could catch fire or be scorched. Do not obstruct the air
outlet.
Timer
For all of the following TIMER programming, proceed firstly with these standard steps:
• Press the button briefly; the 2 left digits of the 4 digits on the LCD display are flashing.
• Press or to adjust the hour.
• Press the button briefly again, the 2 right digits of the 4 digits are flashing.
• Press or to adjust the minutes of the clock in intervals of 5 minutes. The timer is set.
After 10 seconds the time display returns.
Programming the timer for ON - when the unit is OFF.
• Perform the standard steps as described above.
The circular time scale will be on between the ON programmed times
until 24:00. The flashing bar on the time scale indicates the real time and
moves a segment ahead every 30 minutes until it reaches the ON timer
time, then the black segments in the circular time scale will disappear.
6 6
Fan only
on the LCD-display will rotate accordingly.
, set the desired temperature and the unit will heat
or to set the temperature. The 2 digit
Heat
and buttons at the same
witch on again.
button
Timer example