Pioneer PD-217 Operating Instructions Manual page 28

A
7
28
En
8
(PD-217)
B
7
OPEN/CLOSE
0
(PD-217)
TO PLAY ONLY DESIRED TRACKS
Programming a pause (PD-217 only)
Inserting a pause in your program can be very useful when carrying
out recording. Press 8 instead of entering a track number. "PA"
appears on the display.
÷ For example, when recording on both sides of a cassette tape, if
you program a pause after the last track to be recorded on the
first side, program playback will pause at that point to allow you
to switch tape sides. To resume program playback after the
player enters pause mode, press 6 (or 8).
NOTES:
÷ A pause can be programmed only when the program procedure
is performed under stop mode.
÷ A pause cannot be programmed at the beginning of a program,
nor can two pauses be programmed one after the other.
÷ A pause inserted in a program is counted as one step.
÷ If a pause is programmed as the last step of a program, the
player will not enter the pause mode.
To clear all of the program contents
A
In the stop mode, press 7.
B
When the disc tray is ejected, the program contents will be
cleared.