How To Initialize The Tv/Dvd/Vcr - Magnavox CT202MW8 Service Manual

HOW TO INITIALIZE THE TV/DVD/VCR

To put the program back at the factory-default, initialize the TV/DVD/VCR as the following procedure.
< DVD Section >
1. Turn the power on and press [SELECT] button on
the remote control unit to put the TV/DVD/VCR
into DVD mode.
2. Press [1], [2], [3], [4], and [DISPLAY] buttons on
the remote control unit in that order.
Fig. a appears on the screen.
" ******* " differ depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : CLEAR
Fig. a
3. Press [CLEAR] button on the remote control unit.
Fig. b appears on the screen.
" ******* " differ depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : OK
EEPROM CLEAR : CLEAR
Fig. b
When "OK" appears on the screen, the factory
default will be set.
4. To exit this mode, press [CH. o/p] or [SELECT]
button to go to TV mode, or press [STANDBY-ON]
button to turn the power off.
EXIT: SELECT
EXIT: SELECT
1-8-1
< TV/VCR Section >
1. Use the service remote control unit.
2. Turn the power on and press [SELECT] button to
select TV mode. (Use main power on the TV unit.)
3. Press [DISC MENU] button on the service remote
control unit to enter Service mode. (Refer to "How
to enter Service mode" on page 1-7-1.)
4. Press [VOL n] button on the service remote
control unit twice, and confirm that OSD indication
is "7F = FF." If needed, set it to become "7F = FF"
by pressing [CH. o/p] buttons on the service
remote control unit.
5. Confirm that OSD indication on the four corners
on TV screen changes from on and off light
indication to red by pressing [DISPLAY] button. (It
is necessary for one or two seconds.)
6. Press [STANDBY-ON] button to release from
Service mode.
< DTV Section >
1. Use the service remote control unit.
2. Turn the power on and press [SELECT] button to
select DTV mode. (Use main power on the TV
unit.)
3. Press [DISC MENU] button on the service remote
control unit to enter Service mode. (Refer to "How
to enter Service mode" on page 1-7-1.)
4. Confirm that OSD indication on the four corners
on TV screen changes to red by pressing
[DISPLAY] button.
5. Press [STANDBY-ON] button to release from
Service mode.
6. Press [SELECT] button to change to AUX mode.
< Both TV/VCR and DTV Section >
1. Turn the power on and press [SELECT] button to
select DTV mode.
2. Press [DISC MENU] button to enter Service mode.
3. Press [DISPLAY] button to initialize in DTV mode.
4. Press [STANDBY-ON] button to release from
Service mode.
5. Press [SELECT] button to change to AUX mode.
6. Press [DISC MENU] button to enter Service mode.
7. Press [DISPLAY] button to initialize in TV mode.
8. Press [STANDBY-ON] button (or [RETURN] and
[5] buttons) to release from Service mode.
Initializing is complete.
P7754INT