Traxxas 1/16 Slash VXL 4x4 7009 Owner's Manual page 12

If the power indicator doesn't
light green on the transmitter,
check the polarity of the
batteries. Check rechargeable
batteries for a full charge. If you
see any other flashing signal
from the LED, refer to the chart
on page 28 to identify the code.
The following Traxxas High
Current Connector packages
are available from your hobby
dealer. When using adapters, be
careful not to exceed the current
rating of the Molex connector.
Part #3060 Part #3080
Single Male/Female 2-Pack Female
Part #3061 Part #3070
Male Charge Adapter
2-Pack Male
Part #3062
Female Charge Adapter
12 • 1/16th SLASH VXL
TRAXXAS TQ RADIO & VELINEON POWER SYSTEM
i
2. Install the battery pack with
the battery wires facing the
rear of the model.
3. Route the battery wire through
the slot near the vent.
4. Close the battery door, making
sure not to pinch the battery
wires. Be sure both release tabs are fully engaged with the door.
Do not connect the battery pack to the ESC at this time. Note:
always unplug the battery and remove from the model after use.
The Traxxas High Current Connector
Your model is equipped with the patented
Traxxas High-Current Connector. Standard
connectors restrict current flow and are not
capable of delivering the power needed to
maximize the output of the Velineon Brushless Power system.
The Traxxas connector's gold-plated terminals with large contact
surfaces ensure positive current flow with the least amount of
resistance. Secure, long-lasting, and easy to grip, the Traxxas
connector is engineered to extract all the power your battery has
to give.
Using LiPo Packs in Your Model
The VXL-3m is compatible with 2S and 3S LiPo packs, and is
equipped with Low-Voltage Detection circuitry to prevent over-
discharging. Make certain LiPo mode is selected (see page 17 for
details) when using LiPo packs in your model.
Using an Additional Battery for Increased Run Time
Your model only requires one battery pack, but the chassis can
accept two batteries. Your model can be run with two battery
packs to extend run time. The batteries must be connected in
parallel, which will combine the capacity of the two batteries
(for example, two 7.2-volt 1000mAh packs connected in parallel
will deliver a total capacity of 2000mAh, but total voltage will
remain 7.2 volts). This is easily done with a Traxxas parallel
connector (Part #3064, sold separately). Be sure to only use the
parallel connector with identical battery packs; do not mix batteries
of different chemistries or capacities.
Battery Wire Slot
When operating your model with two batteries, be careful
to monitor the temperature of the speed control and motor
to prevent overheating. Stop running your model and allow
it to cool if the speed control's thermal overload protection
activates or if the motor temperature exceeds 200° F.
Battery Orientation
For best on-road handling with two battery packs,
consider installing stiffer springs on your model.
Using an Additional Battery For Increased Speed
An additional battery may also be used to increase the top speed of
your model to 50+mph by connecting the batteries in series using
a Traxxas series connector (Part #3063, sold separately). This also
requires a gearing change as described on page 24.
50+mph Battery and Gearing Installation Instructions
1. Install the included high-speed pinion gear as described in
Pinion Gear Installation Instructions on page 24. Install the
supplied battery as described on page 11.
2. Install an identical Power Cell Series 1 battery (Part #2925, sold
separately) in the opposite battery compartment.
3. Plug both batteries into the Traxxas series connector (Part
#3063, sold separately). The harness connects the two packs in
series. The two 7.2-volt 6-cell battery packs will operate as one
14.4-volt 12-cell battery pack.
4. Plug the Traxxas series connector into the speed control.
Precautions
•
The High Speed dual-battery and gearing configuration
is for high-speed running only. Avoid repetitive hard
acceleration to prevent overstressing the motor, speed
control and batteries.
•
Make certain both batteries are fully charged before
installing them in your model. Installing a fully charged pack
and a partially discharged pack may lead to over-discharging
and damage to the partially discharged battery.
•
Do not mix batteries of different brands, chemistries or
capacities. Only genuine Traxxas batteries are approved for
dual-battery use in this model.
•
Stop running your model and allow it to cool if the speed
control's thermal overload protection activates or if the
motor temperature exceeds 200° F.