Net Dimension; Installation And Accessory Parts - Haier HLT20E Service Manual

Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Adjust the Installation position
The largest allowed slope of the shank base of the machine is 2 . The slanting or rough ground will
result in unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal
Hang the plumb to confirm it's horizontal.
<2
Install the drain hose
First install the drain hose hook on the parts of
outer drain hose component.
Put the drain hose clamp on the outer drain hose,
insert the outer drain hose into the joint for it, and
then clutch tightly with drain hose clamp.

INSTALLATION AND ACCESSORY PARTS

Adjust the adjustable feet
1) To twist the adjustable foot, please first lift up
the side of the foot slightly, and twist the foot.
2) Fasten the nut after adjustment.
High
Outer drain hose
component
7

NET DIMENSION

Unit mm
Figure 1
Adjustable foot
Low
Drain hose hook
Drain hose clamp
Drain hose joint