Safety Precautions; Speed Control - Traxxas E Revo 5603 Owner's Manual

el = Myriad Semi Bold
All instructions and
precautions outlined in this
manual should be strictly
followed to ensure safe
operation of your model.
bluehighway font
2 3 3+ 4 5
This model is not intended
for use by children under
14 years of age without the
supervision of a responsible
and knowledgeable adult.
Previous experience with
radio controlled models
is recommended. Models
require a higher level of
setup, maintenance, or
support equipment.
For Expert Drivers
1
4 • E-Revo

SAFETY PRECAUTIONS

All of us at Traxxas want you to safely enjoy your new model. Operate your
model sensibly and with care, and it will be exciting, safe, and fun for you and
those around you. Failure to operate your model in a safe and responsible
manner may result in property damage and serious injury. The precautions
outlined in this manual should be strictly followed to help ensure safe
operation. You alone must see that the instructions are followed and the
precautions are adhered to.
IMPORTANT POINTS TO REMEMBER
Your model is not intended for use on public roads or congested areas
where its operation can conflict with or disrupt pedestrian or vehicular traffic.
Never, under any circumstances, operate the model in crowds of people. Your
model is very fast and could cause injury if allowed to collide with anyone.
Because your model is controlled by radio, it is subject to radio interference
from many sources that are beyond your control. Since radio interference
can cause momentary losses of radio control, always allow a safety margin in
all directions around the model in order to prevent collisions.
The motors, batteries, and speed control can become hot during use. Be
careful to avoid getting burned.
Don't operate your model at night, or anytime your line of sight to the model
may be obstructed or impaired in any way.
Most importantly, use good common sense at all times.
BATTERIES AND BATTERY CHARGING
Your model uses rechargeable batteries that must be handled with care for
safety and long battery life. Make sure to read and follow all instructions and
precautions that were provided with your battery packs and your charger. It is
your responsibility to charge and care for your battery packs properly. In addition
to your battery and charger instructions, here are some more tips to keep in mind.
Never leave batteries to charge unattended.
Remove the batteries from the model while charging.
Always unplug the batteries from the electronic speed control when the
model is not in use and when it is being stored or transported.
Allow the battery packs to cool off between runs (before charging).
Children should have responsible adult supervision when charging and
handling batteries.
Do not use battery packs that have been damaged in any way.
Do not use battery packs that have damaged wiring, exposed wiring, or a
damaged connector.
Only use approved chargers for NiMH battery packs (such as the Traxxas EZ-
Peak ™ Charger, Part #2930). Do not exceed the maximum charge rate of 4 amps.
Do not short-circuit the battery pack. This may cause burns and severe
damage to the battery pack.
Do not burn or puncture the batteries. Toxic materials could be released. If
eye or skin contact occurs, flush with water.
Store the battery pack in a dry location, away from heat sources and
direct sunlight.
Nickel Metal Hydride batteries must be recycled or disposed of properly.
Recycling Your Traxxas Power Cell NiMH Battery
Traxxas strongly encourages you to recycle your Power Cell battery when
it has reached the end of its useful life. Do not throw your battery in the
trash. All Power Cell battery packs display the RBRC (Rechargeable Battery
Recycling Corporation) icon, indicating they are recyclable. To find a
recycling center near you, ask your local hobby dealer or visit www.rbrc.org.

SPEED CONTROL

Disconnect the Batteries: Always disconnect the batteries from the speed
control when not in use.
Transmitter on First: Switch on your transmitter first before switching on the
BELOW TEXT HAS BEEN UPDATED on 3-14-07
speed control to prevent runaways and erratic performance.
Don't Get Burned: The heat sink can get extremely hot, so be careful not to Kent wants maintenance text to be at the END
touch it until it is cool. Supply adequate airflow for cooling.
6 to 14-cells Only: Always adhere
to the minimum and maximum
Choose the Model That is Right For You.
limitations of the EVX-2 as stated
in the specifications table. Do
not mix battery types and
No previous experience with radio controlled models is required.
capacities. Use the same
Models require a minimum of setup, maintenance, or support equipment.
voltage and capacity for both
Do not mix battery
batteries. Using mismatched
capacities. Use two
battery packs could damage
batteries with the
Previous experience with radio controlled models is recommended.
the batteries and electronic same capacity.
Models require a higher level of setup, maintenance, or support equipment.
speed control.
Use Stock Connectors: If you decide to change the battery
Previous experience with radio controlled models is mandatory. These
or motor connectors, only change one battery or motor connector at a time.
models are capable of high speeds, requiring experienced driving control.
This will prevent damage from accidentally mis-wiring the speed control.
Models require detailed setup, and/or maintenance procedures with required
Please note that modified speed controls can be subject to a rewiring fee
support equipment.
when returned for service. Removing the battery connector on the speed
Previous experience with radio controlled models is mandatory. control or using connectors with no reverse-polarity protection on the speed
control will void the product's warranty.
These models are capable of very high speeds and require an even higher
Insulate the Wires: Always insulate exposed or damaged wiring with heat
level of skilled driving control. Models require detailed setup, and/or mainte-
shrink tubing to prevent short circuits
nance procedures with required support equipment.
Always Use Heat Sinks: Three heat sinks are factory-installed on the speed
For Expert Drivers Only. This product is capable of extreme speed
control and must be used for maximum cooling and performance.
and acceleration! It carries our highest skill level rating and is intended
No Reverse Voltage: The speed control is not protected against reverse polarity
for expert drivers only. Experience with nitro-powered radio controlled
voltage. When changing the battery and/or motor, be sure to install the same
models is required!
type of connectors to avoid reverse polarity damage to the speed control.
Removing the battery connectors on the speed control or using the same-
gender connectors on the speed control will void the product's warranty.
Do Not Let the Transistor Tabs Touch: Never allow the three separate
transistor banks to touch each other or any exposed metal. This will create a
short circuit and damage the speed control. (For example, laying a metal tool
across the heat sinks can damage the speed control.)
No Schottky Diodes: External Schottky diodes are not compatible with
reversing speed controls. Using a Schottky diode with the EVX-2 will damage
the ESC and void the 30-day warranty.
N
M
Do not use a 6-cell 7.2V
battery in combination
with a 7-cell battery
M
8.4V pack.
P
c
d
e
P
c
c
r
F
a
f
m