Installations/Connections - Panasonic WV-NF302 Installation Manual

Installations/Connections

Caution:
ONLY CONNECT THIS TO 12 V DC CLASS 2 POWER SUPPLY.
Installation of the camera
Before starting the installation/connection, prepare the required devices and cables. Refer to
the corresponding pages for further information.
z Make a hole in the ceiling and fix the provided camera mount bracket over it. ( page 19)
x Line up the ends of the cables (12 V DC power cable, LAN cable (category 5 or higher),
cable from an external device and the provided audio cable) and the safety wire, and then
bundle them using the provided cable tie. ( page 20)
c Attach the provided safety wire to the safety wire holder of the camera. ( page 20)
v Make the connections of the 12 V DC power cable, LAN cable, audio cable and cable from
an external device. ( pages 22 - 24)
b Mount the camera onto the camera mount bracket. ( page 20)
n Adjust angle of the camera, angular field of view and focus. ( pages 26 - 28)
Ceiling
Camera mount bracket
(provided as a standard
accessory)
Cable tie (provided as a
standard accessory)
Note:
When the camera is installed just above the photogenic subject
as q in the illustration, it may be difficult to adjust angular field
of view focusing around the subject.
To easily adjust angular field of view focusing around the sub-
ject, increase an angle (A) as w.
18
12 V DC power cable
LAN cable
Cable from an external device
Audio cable (provided as a standard
accessory)
Bundle the cables and
the safety wire together
Safety wire
Anchor bolt x4
(not provided)
Safety wire holder
q
w
(A)
Subject