Drainage - Desa AC 9410 EH Instruction Manual

DRAINAGE

During the process of cooling, some water will be extracted from the air into the
unit. If the reservoir is full, both the compressor and the motor will stop. When
this occurs, the 'comp' indicator will flash
For the unit to function again, the water must be drained in one of the following
ways:
1. Turn off the air conditioner
2. Position the water tray underneath
the drain hole
3. Remove the drain knob & rubber
plug from the drain hole and allow
the water to drain out
4. Replace the rubber plug in the drain
hole whilst emptying the water tray
5. Repeat stages 3 and 4 until the unit
is emptied
6. Replace the rubber plug and tighten
the drain knob firmly
7. Switch on the unit – (the 'comp' light
should not be flashing)
If you wish to operate the unit without the need to empty the water tank, please:
• Remove the drain knob and rubber
plug and retain for future use
• Connect the drain tube supplied to
the water outlet as shown and place
the other end into a drain
• The drain tube may be extended by
adding an extension tube and using
a suitable connector (not supplied)
11