Table of Contents
Advertisement
Keys
Key(s)
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Stan dard wrench sizes are listed.
(1) 1/2" wrench
(2) 7/16" wrenches
Pliers
When right or left hand is mentioned in this
man ual, it means when you are in the operating
po si tion (seated be hind the steer ing wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
•
Remove all accessible loose parts and
parts cartons from carton .
•
Cut along dotted lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
•
Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
TO CHECK BATTERY
1. Lift seat to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
•
For battery and battery cable installation
see "REPLACING BATTERY" in the
"Service and Adjustments" section in
this manual.
UNASSEMBLED PARTS
ASSEMBLY/PRE-OPERATION
Tire pressure gauge
Utility knife
Slope Sheet
TO ADJUST SEAT
•
Sit in seat.
•
Lift up adjustment lever (A) and slide seat
until a comfortable position is reached
which allows you to press clutch/brake
pedal all the way down.
•
Release lever to lock seat in position.
7
Battery
(2) Hex Bolts
(2) Nut Keps
Label
A
Advertisement
Table of Contents
