Auto Memory Store; Preset Scan; Rds Function; Af (Alternative Frequencies) - Hyundai H-CDM8042 Instruction Manual

Operation
needed); press MEM button and rotate
VOLUME knob to choose a number under
which the needed station is stored (1-6), and
finally press OK button to recall the station.

Auto memory store

Select a band, press and hold OK button
to enter auto store mode. The radio will
automatically store 6 stations to the 6 preset
memories of the current band. To stop auto
store, press this button again.
During auto station preset, the unit will
search and store stations with the strong signal
first, and then weaker signal stations until the
memories are full.

Preset scan

Select a band, press OK button to scan all
preset stations in the memories of the current
band, each preset scan for 5 seconds. To stop
preset scan, press the button again.

RDS function

RDS (Radio Data System) service availability
varies with areas. Please understand if RDS
service is not available in you area, the following
service is not available, either.

AF (Alternative Frequencies)

function

Press and hold SEL button, then press it
repeatedly to select AF. Rotate VOLUME knob
to set this function on/off. If the AF function is
on, the display will show "AF".
When the radio signal strength is poor,
enabling the AF function will allow the unit to
automatically search another station with the
same PI (Program Identification) as the current
station but with stronger signal strength, so that
you do not have to retune the stations when
driving between different transmitter coverage
areas. When AF symbol is on, it means RDS
information is received; when AF symbol is
flashing, it means RDS information is not yet
received. If RDS service is not available in your
area, turn off the AF mode.
10
TA (Travel Announcement) / TP
(Travel Program Identification)
Enable or disable TA mode by pressing and
holding BAND button. Default setting is OFF.
When TA function is activated, it will search
the station with TA information automatically.
If there is no TA information, it will search the
station with TP information automatically, if
there is no TP information either, it will return to
the previous station after searching.
When receiving the station with TP
information but without TA information,
TP icon is on and TA icon keeps blinking;
when receiving the station with TP and TA
information, both TP and TA icons are on.
When playing in other mode and TA
information is received, it will change to the
radio mode automatically. After playing over, it
will return to the previous mode.
PTY (Program Type) (for FM radio)
Press and hold MEM button to open PTY
program type list, and turn VOLUME knob to
select a PTY type. After selecting the program
type you want, press MEM button to search.
Press the button again to stop the PTY search.
If PTY code is different or not available, then
display blinks with "PTY NONE".
REG (Regional) function
Press and hold SEL button, then press it
repeatedly to select REG, then rotate VOLUME
knob to set this function on/off. Default setting
is off for REG.
When REG is enabled (on), the receiver
accepts regional variants of the tuned station
with REG icon turned on.
When REG is disabled (off), the receiver
ignores regional variants.
Mono/Stereo control (in FM radio
mode)
Press and hold SEL button, then press it
repeatedly until the display shows STEREO
(MONO). Turn VOLUME knob to switch
between ON (stereo reception) or OFF (mono