GE JB960 B Technical Service Manual page 21

Oven Liner Removal
8. Remove 7 screws from inside the oven
cavity (see illustration to right), which se-
cure the oven liner to the frame/cabinet (1
on each front side of the liner, 2 on lower
back wall of liner and 3 across the top front
of the liner).
9. From inside the oven cavity, remove the
smoke eliminator chimney (2 screws).
10. Remove the oven vent chimney - if this is
not removed the oven liner can catch on it
during reinstallation.
11. Remove the meat probe recepticle from
inside the oven cavity top (2 screws).
12. Remove the two front screws which se-
cure the front edge of the broil element
bracket to the top of the oven liner (do not
remove the screws which mount the broil
element to the back wall).
13. Gently pull the liner forward, making sure
to keep the liner evenly spaced on each
side as you pull it forward. Note: you will
be removing the oven liner with the broil
element, convection fan assembly, and
oven lamp assembly still mounted to the
liner.
OVEN LINER REINSTALLATION
1. After transfering the convenction fan as-
sembly, lamp assembly, sensor, and broil
element to the new liner; slide the new liner
back into the cabinet frame.
2. Install the two screws from the back of the
range which secure the oven liner to the
oven frame, taking care to ensure that the
2 liner hooks catch into the slots in the back
wall of the oven.
3. Install the two screws which mount the
oven liner to the bake element housing pan
(2 screw holes located inside oven liner,
lower back wall). You will need to move/
adjust the bake element housing pan in
order to line up the holes in the liner with
those in the pan.
4. Reinstall the oven vent and smoke elimi-
nator chimney, taking care to properly
mate the chimney to the oven vent located
directly above it (secured with 2 screws).
5. Reinstall the meat probe receptical, and
all remaining interior oven liner hardware.
6. Reinstall the bake element and cooktop,
taking care to reconnect all ground straps
and ensure that all wiring is relocated back
into its original holding restraints.
(cont).
– 19 –