The Traxxas Tq 2.4Ghz Radio System - Traxxas Revo 3.3 5309 Owner's Manual

Hide thumbs Also See for Revo 3.3 5309:

Owner's manual (49 pages)

Table of Contents

Applying The Decals

The main decals for your

model have been applied at

the factory. The decals are

printed on self-adhesive clear

mylar and are die-cut for easy

removal. Use a hobby knife

to lift the corner of a decal

and lift it from the backing.

To apply the decals, place one

end down, hold the other end

up, and gradually smooth the

decal down with your finger

as you go. This will prevent air

bubbles. Placing both ends

of the decal down and then

trying to smooth it out will

result in air pockets.

8 • Revo 3.3

THE TRAXXAS TQ 2.4GHZ RADIO SYSTEM

Your Revo is equipped with the TQ 2.4GHz radio system. The TQ 2.4GHz is a 3-channel system that provides control for up to three outputs. Revo is equipped with two high-

torque steering servos connected via dual Channel 1 outputs. The TQ 2.4GHz works in conjunction with the OptiDrive

input and output signals for the throttle and shifting servos (channels). The OptiDrive monitors the voltage of the on-board RX Power Pack. The "Function" LED will flash red if

the battery voltage is too low. The 2.4GHz 4-channel receiver is also equipped with low-voltage detection and will enter fail-safe mode if battery voltage drops too low.

TQ 2.4GHZ TRANSMITTER

Antenna

Steering Wheel

Throttle

Throttle Neutral

Adjust

Trim

Steering

Trim

Shift

Switch

Throttle