Cub Cadet Z-Force 44 User Manual page 23

Ride on mower
Hide thumbs Also See for Z-Force 44:
Table of Contents

Advertisement

Maintenance
WARNING!
Before performing any maintenance or
repairs, disengage the PTO, move the drive control
levers to the neutral position, engage the parking
brake, stop the engine and remove the key to
prevent unintended starting.
Engine
Refer to the Kohler Owner's Manual for all engine maintenance
intervals, procedures, specifications and instructions.
Changing the Engine Oil
WARNING
! If the engine has been recently run, the
engine, muffler and surrounding metal surfaces will
be hot and can cause burns to the skin. Exercise
caution to avoid burns.
To complete an oil change, proceed as follows:
1.
Run the engine for a short time to warm the engine oil. The
oil will flow more freely and carry away more impurities.
Use care to avoid burns from hot oil.
2.
Locate the oil drain hose on the engine.
3.
Route the free end of the oil drain hose toward an
appropriate oil collection container with at least a 2.5 quart
capacity, to collect the used oil. Remove the oil fill cap/
dipstick from the oil fill tube.
4.
While holding the free end of the oil drain hose over the oil
collection container, unscrew the square-head hose plug
from the end of the hose. See Fig. 6-1. Drain the engine oil
into the collection container.
Square-Head
Hose Plug
Figure 6-1
5.
After draining the oil, wipe any residual oil from the oil
drain hose. Thread the square head plug into the drain
hose fitting and fully tighten the plug.
6.
Refill the engine with new oil. Refer to the Kohler Owner's
Manual for information regarding the volume and weight
of engine oil.
Air Cleaner
Service the pre-cleaner and air filter as instructed in the Kohler
Owner's Manual.
Spark Plug
The spark plugs should be cleaned and the gap reset once a
season. Refer to the Kohler Owner's Manual for correct plug type
and gap specifications.
Hydrostatic Transmission
The zero turn tractor is equipped with dual integrated
hydrostatic pumps/transaxles that are sealed and are
maintenance-free. Fluid levels in the transaxles cannot be
checked and fluid cannot be added or changed. The fluid level
in the expansion reservoir must be maintained at 1⁄2" to 1" above
the bottom of the tank.
NOTE: If a pump fails or proper level in the expansion reservoir
is not maintained, contact your Cub Cadet dealer. Do not
disassemble the pump/motors.
General Battery Information
WARNING!
Should battery acid accidentally splatter into
the eyes or onto the skin, rinse the affected area
immediately with clean cold water. If there is any
further discomfort, seek prompt medical attention.
If acid spills on clothing, first dilute it with
clean water, then neutralize with a solution of
ammonia/water or baking soda/water.
NEVER connect (or disconnect) battery
charger clips to the battery while the charger is
turned on, as it can cause sparks.
Keep all sources of ignition (cigarettes,
matches, lighters) away from the battery. The gas
generated during charging can be combustible.
As a further precaution, only charge the
battery in a well ventilated area.
Always shield eyes and protect skin and
clothing when working near batteries.
Batteries contain sulfuric acid and may
emit explosive gases. Use extreme caution when
handling batteries. Keep batteries out of the reach
of children.
s
6 — M
ectiOn
& a
aintenance
djustMents
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z-force 48

Table of Contents