JVC KD-G815 Service Manual page 9

3.1.4 Removing the front chassis
(See Figs.7 and 8)
• Prior to performing the following procedure, remove the front
panel assembly, heat sink and top chassis assembly.
(1) From the both sides of the top chassis assembly, remove
the two screws E attaching the front chassis. (See Figs.7
and 8)
(2) Take out the front chassis.
3.1.5 Removing the mechanism control board
(See Fig.9)
• Prior to performing the following procedures, remove the front
panel assembly, heat sink and top chassis assembly.
Reference:
Remove the front chassis as required. (Refer to "3.1.4 Remov-
ing the front chassis")
(1) Disconnect the card wire from the connector
mechanism control board.
(2) Remove the five screws F attaching the mechanism control
board.
(3) Release the claw a, and take out the mechanism control
board.
Reference:
After attaching the mechanism control board, attach it to the
claw a and pass the slot b of it into the boss of the CD mech-
anism assembly.
Top chassis assembly
E
Mechanism control board
CN601 on the
F
Slot b
Fig.7
Top chassis assembly
Front chassis
Fig.8
F
Fig.9
E
Front chassis
CN601
Claw a
F
(No.MA170)1-9