Adjusting The Dryer's Electronics For Very Soft Water - Miele T 8164 WP Operating Instructions Manual

Settings
Adjusting the dryer's
electronics for very soft water

This setting should only be
altered if the water is so soft that it is
likely to cause the electronics which
sense residual moisture in the
laundry to give false readings.
Important
If the dryer is installed in an area with
very soft water, you should contact
your local water supplier for information
and advice regarding water hardness
and water conductivity. If the water
conductivity is less than 150 μS, the
following setting will need to be
activated.

Only activate this programmable
function if these conditions are
present. Otherwise drying results will
be unsatisfactory.
Follow steps (,, ...) to
programme and store in memory.
Before you begin, ensure that:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is pointing
to Finish.
 Press Start and keep it pressed in
whilst carrying out steps -.
 Switch the dryer on.
 Wait until the indicator light for the
Start button comes on . . .
 . . . and then release the Start
button.
52
 Turn the programme selector to
Gentle smoothing.
The Empty container indicator light will
flash on and off slowly once and then
on and off quickly twice.
The option selected will be displayed
by a number which will alternate with
.
 Factory default setting
 Adjusted for very soft water (with
low conductivity)
(The Clean out airways indicator light
will also flash once)
 Pressing the Start button switches
between the options.
 Switch the dryer off.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check the setting:
 Carry out steps -.
 Switch the dryer off after checking.