Handling The Remote Control - Danby DPA120B1WB Instructions Manual

Handling the Remote Control

CAUTIONS
The air condiitioner will not respond if curtains, doors or other materials
block the signal from the remote control to the unit.
P e r v e t n a n y q i l
the remote control to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
If other electrical appliances react to the remote control, either move
these appliances to another location or consult your local dealer.
Replacing the Batteries
Location of the Remote Control.
Use the remote control within a distance of 8
meters from the appliance, pointing it towards the
receiver. Reception is confirmed by a beep.
u d i f o r m c o n a t t c i w
The remote control is powered by two dry
batteries(2-AAA) located in the rear
part and protected by a cover.
(1) Remove the cover by pressing down and sliding it off.
(2) Remove the old batteries and insert the new
(3) Reattach the cover by sliding it back into
.
NOTE:
remote control erases all programming.
After inserting new batteries, the remote
controll must be reprogrammed.
h t h t e e r m o e t c o t n
.
batteries,placing the(+) and (-) ends correctly.
position.
When the batteries are removed, the
2
o r . l D o n t o e x p o s e