Timer Setting - Danby DPA120B1WB Instructions Manual

Timer Setting

Pressing the
time of the unit. Pressing the
will set the auto-off time of the unit.
To Set the Auto-On Time.
1. Press the
control will display TIMER ON, the last auto-on
time setting and the LCD display area will show
an 'h.' Now it's ready to reset the auto-on time.
2. Push the
auto-on time. Each time you press the button,
1
the time increases by 30 minute increments, up
2
to 10 hours, then by 1 hour increments up to 24
hours.
3. After turning the TIMER ON, there will be a one-
half second delay before the remote control
transmits the signal to the air conditioner. Then,
after approximately 2 more seconds, the "h"
will disappear and the set temperature will
re-appear on the LCD display window.
To Set the Auto-Off Time.
1. Press the
control will show TIMER OFF, the last auto-off
time setting, and the LCD display area will show
an "h." Now it is ready to reset the auto-off time.
2. Push the
desired auto-off time. Each time you press the
button, the time increases by 30 minute
increments up to 10 hours, then by 1 hour
increments up to 24 hours.
3. After setting the TIMER OFF ,there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "h" will disappear and the set temperature
will re-appear on the LCD display window.
9
button will set the auto-on
button. The remote
button again to set the desired
button. The remote
button again to set the
button