Setup & Installation - Yard Works YW65PFF Instruction Manual

Positioning The Pump
1. Place the pump close to the water that is required to be pumped (Fig. 1).
Note: Ensure the pump is no further than 5m away from the water's edge.
2. Fill the engine crank case with oil (not included).
Note: SAE 10W-30 oil is recommended, refer to the maintenance section for more
information.
Suction Inlet
Connecting Hose or Pipe to the Suction Inlet
Note: Keep all hoses short and as straight as possible, failure to do so may decrease the pressure pumps performance.
Note: It is recommended that a filter (27) and check valve (not included) is installed at the end of the suction hose or pipe,
in order to prevent long priming periods and unnecessary damage as a result of stones and solid foreign materials
entering the pump.
Note: Reinforced or ridge suction hoses are required on the suction line to prevent the pipe from collapsing due to
pressure from suction.
Caution: All connections must be air tight, failure to do so may result in an air leak which can prevent the pump
from priming. It is recommended that a thread sealant (not included) and/or Teflon tape (not included) is used on
threads to ensure a water tight seal and prevent any leakage during assembly.
1. Assemble the 40mm (1
side of the suction hose (Fig. 2).
2. Tighten the 40mm (1
against the filter (27) strainer (Fig. 2)
3. Assemble the 40mm (1
collar (23) in (Fig. 3).
Note: Ensure the 40mm (1
failure to do so may result in an air leak.
4. Assemble the 40mm (1
the outlet side of the suction hose (Fig. 4).
5. Add thread sealant (not included) and/or Teflon tape (not included) on to the
suction inlet (13).
SETUP & INSTALLATION
/ ") hose clamp (25) and filter (27) strainer to the intake
1
2
/ ") hose clamp (25) tightly ensuring it clamps the hose
1
2
/ ") hose adaptor (24) by inserting into the 40mm (1
1
2
/ ") o-ring (26) is fitted into the 40mm (1
1
2
/ ") hose clamp (25) and the assembled inlet adaptor to
1
2
/ ")
1
2
/ ") collar (23),
1
2
10
Fig. 1
Fig. 2
Fig. 3
Fig. 4