Burners - Monogram ZGU384L Technical Service Manual

To remove the burner valve on model ZGU384:
1. Remove the maintop. (See
2. Remove the indicator light assembly. (See
Indicator Light Assembly
3. Lift the ignitor switch from the burner valve
stem. (See
Ignitor and Light Switch Assembly.
4. Remove the / -in. nut and separate the Hi-Lo
9
16
gas tube from the burner valve.
5. Remove the / -in. nut and separate the Simmer
7
16
gas tube from the burner valve.
/
7
-in. Nut
16
Simmer Gas Tube
Hi-Lo Gas Tube
/
9
-in. Nut
16
6. Remove the four ¼-in. hex-head screws that
attach the valve access plate to the bottom of
the burner box.
7. Remove the ¼-in. hex-head screw that attaches
the valve to the manifold.
Caution: Ensure the screw seal and the valve seal
are in place BEFORE installing the valve.
.)
Maintop
.)
)
– 21 –

Burners

Note: The following describes the procedure to
remove the X-High Output burner.
To remove the X-High Output burner:
Note: Because the X-High Output burner has a
larger maintop opening, it is not necessary to
remove the maintop to replace this burner.
1. Remove the X-High Output burner cap and
burner head.
2. Remove three T-15 Torx screws and the two
T-15 Torx screws that attach the X -High Output
burner base to the maintop.
3. Lift the burner base, then disconnect the ignitor
wire.
4. Remove the / -in. nut and separate the Hi-Lo
9
16
gas tube from the burner.
5. Remove the -in. nut and separate the Simmer
7 /
16
gas tube from the burner.
6. Remove the two ¼-in. hex-head screws that
attach the burner to the burner box.
Simmer Gas Tube
Burner
Hi-Lo Gas Tube
(Continued next page)