Table of Contents
Advertisement
INSTALLING TRANSMITTER BATTERIES
Your TQi transmitter uses 4 AA batteries. The battery compartment
is located in the base of the transmitter.
1. Remove the battery compartment door by pressing the tab and
sliding the door open.
2. Install the batteries in the correct orientation as indicated in
the battery compartment.
3. Reinstall the battery door and snap it closed.
4. Turn on the transmitter and check the status indicator for a solid
green light.
If the status LED flashes red, the transmitter
batteries may be weak, discharged or possibly
installed incorrectly. Replace with new or
freshly charged batteries. The power indicator
light does not indicate the charge level of the
battery pack installed in the model. Refer to the
Troubleshooting section on page 24 for more
information on the transmitter Status LED codes.
TRAXXAS TQ
CHARGING THE BATTERY PACK
The included charger can be used to charge the included battery pack.
The battery pack should be removed from the vehicle before charging.
Do not leave the battery unattended while charging.
battery to become slightly warm as it nears full-charge, but the battery
should never become hot. If the battery becomes hot, disconnect it from the
charger immediately.
1. Plug the charger into the wall. The LED on the charger should
glow green.
2. Connect the included battery pack to the charger output cord. The
LED will glow red indicating the battery is charging.
3. The battery should charge for approximately 8 ½ hours. The LED
will turn green when the battery is fully charged. Disconnect the
battery from the charger after charging.
2
1
Using Other Chargers
Another convenient option for charging the included battery
is an AC peak-detecting charger that plugs directly into an AC
wall outlet, such as the TRX EZ-Peak
special peak-detection circuitry that automatically shuts the
charger off when the battery is fully charged.
For faster charging, the included battery may be charged at
4 amps. The TRX EZ-Peak
is a 4 amp charger and will charge
™
the included battery in about 45 minutes!
Caution: Never use a 15-minute timed charger to recharge
your model's battery packs. Overcharging may result, causing
damage to the battery packs.
RADIO SYSTEM
i
It is normal for the
3
™
(Part #2930). It contains
If the power indicator doesn't
light green, check the polarity
of the batteries. Check
rechargeable batteries for
a full charge. If you see any
other flashing signal from the
LED, refer to the chart on page
24 to identify the code.
Use the Right Batteries
Your transmitter uses AA
batteries. Use new alkaline
batteries, or rechargeable
batteries such as NiMH
(Nickel Metal Hydride)
batteries in your transmitter.
Make sure rechargeable
batteries are fully
charged according to the
manufacturer's instructions.
If you use rechargeable
batteries in your
transmitter, be aware
that when they begin
to lose their charge, they lose
power more quickly than
regular alkaline batteries.
Caution: Discontinue running
your model at the first sign of
weak batteries (flashing red
light) to avoid losing control.
2,3
SLASH • 11
Advertisement
Table of Contents
