Intercom - Panasonic KX-TG1223BX Operating Instructions Manual

TG1223-1233BX(e-e).book Page 48 Wednesday, November 15, 2006 3:32 PM
Multi-unit Operation
Cancelling a base unit
A handset can be registered to a maximum
of 4 base units. A handset can cancel a base
unit that it is registered to. This allows the
handset to "forget" the base unit.
1
Press {j/OK}.
2
Select "Handset Setup", then press
{>}.
3
Select "Registration", then press
{>}.
4
Enter "335".
5
Select "Cancel Base", then press
{>}.
6
Enter "0000" (default handset PIN).
L If you changed the PIN, enter it (page
29).
7
Select the base unit(s) you want to
cancel, by pressing the desired base unit
number.
L The selected base unit number(s) will
flash.
L To cancel a selected base unit
number, press the number again. The
number will stop flashing.
8
Press {j/OK}.
9
Select "Yes", then press {>}.
10
Press {ih}.
Note:
L To register the handset to another base
unit or to the same base unit again, see
manual registration (page 47).
Increasing the range of the base
unit
You can increase the range of the base unit
by using a DECT repeater. Please use only
the Panasonic DECT repeater noted on
page 5. Consult your Panasonic dealer for
details.
48
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode on.
Turning the repeater mode on/off
1
Press {j/OK}.
2
Select "Base Unit Setup", then
press {>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
35).
4
Select "Other Options", then press
{>}.
5
Select "Repeater Mode", then press
{>}.
6
Select "On" or "Off", then press {>}.
7
Press {ih}.
Note:
L After turning repeater mode on or off:
– Certain icons displayed on the base unit
will disappear for a moment (KX-
TG1233 only).
– w will flash on the handset
momentarily. This is normal. The
handset can be used once w stops
flashing.
L While the repeater mode is turned on,
audible call announcements may not be
heard from the handset speaker (KX-
TG1233 only).

Intercom

Intercom calls can be made between
handsets/base unit in the same radio cell.