Charging The Battery - Razor Bistro Owner's Manual

ASSEMBLY AND SET-UP
q Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and
your purchase.
1
Using a bicycle style tire pump
equipped for a Schrader-type valve,
inflate the tires to the PSI
indicated on the sidewall of the
tires.
q Side View Mirror Assembly Instructions (if applicable)
Tools required: 3mm key wrench and 14mm wrench
1
Adjust the side view mirror
sockets into fixed place and
tighten down with 3mm allen
wrench.
q Charging the Battery
Your Pocket Mod may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.
• Initial charge time: 18 hours
• Recharge time: up to 12 hours
depending on the level of depletion
Charger
Port
Charger
Plug
2
Insert the side view mirrors into
sockets and tighten down the nuts
with 14mm wrench.
• Run time: Up to 30 minutes of continuous ride time
• Average battery life: 250 charge/discharge cycles
1
Turn power OFF before
charging. Plug the charger into the
charger port.
Note: Be sure to properly align
the groove on the charger input
plug with the corresponding
socket on the case; otherwise,
no charging action will occur.
2
Plug the charger into a wall
outlet. If the lights on charger do
not light up, check the power to
the outlet. If necessary, try a differ-
ent outlet.
4
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
your Pocket Mod tires, first make
sure the pressure gauge is working,
then use very short bursts to
inflate to the correct PSI. If you
inadvertently over-inflate the
tires, release the excess pressure
immediately.
WARNING:
Rechargeable batteries are only to
be charged under adult supervision.
Always disconnect your Pocket Mod
from the charger before cleaning
with liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual "charging" and
"charged" status indications for
your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.