Connecting The Network Video Encoder Directly To A Dhcp; Connecting The Network Video - Samsung SPE-101 User Manual

CONNECTING THE NETWORK VIDEO ENCODER DIRECTLY
TO A DHCP BASED DSL/CABLE MODEM
Network Video
Encoder
1. Use the cross cable to manually connect between your PC and network video
encoder.
2. Run the IP Installer and change the IP address of the network video encoder so that
you can use the web browser on your desktop to connect to the Internet.
3. Use the Internet browser to connect to the network video encoder.
4. Move to [Setup] page.
5. Move to [Network] – [DDNS] and configure the DDNS settings.
6. Move to [Network] – [Interface], and set the network type to [DHCP].
7. Connect the network video encoder, which was removed from your PC, directly to
the modem.
8. Restart the network video encoder.

M
For registering the DDNS settings, refer to "Registering with DDNS". (page 41)

For configuring the DDNS settings, refer to "DDNS". (page 40)

For setting the network type, refer to "Interface". (page 39)
INTERNET
DSL/Cable Modem
External Remote PC
DDNS Server
(Data Center, KOREA)
English _17