Advertisement
QUICK REMOVAL and INSTALLATION INSTRUCTIONS
Removal of Existing Alarm
1- Remove existing installed Firex
alarm unit from the wall/ceiling
by turning the existing unit counter-
clockwise and disengaging it from
the existing mounting plate.
2 - Disconnect the power harness from
the existing alarm unit. Next, remove
the existing mounting plate from the
wall/ceiling by loosening the two
screws with a screwdriver. DO NOT
DISCONNECT THE WIRING HARNESS
FROM THE HOUSE WIRING.
Return of Existing Alarm
3 - Place the removed alarm unit and existing
mounting plate into the supplied return box
(postage has been prepaid) place the sealed box with
the US Postal Service for delivery back to the manufacturer.
Replacement Alarm Unit Installation
4 - Install the replacement mounting plate on
the wall/ceiling using the screws from Step 2.
Position the power harness so that it hangs
through the hole in the installed replacement
mounting plate. For complete replacement
mounting plate installation instructions, please
see installation instructions included with the
replacement alarm.
5 - Plug the supplied wiring adapter into the back of the
replacement alarm. Connect the power harness
(hanging from the wall/ceiling) into the wiring adapter.
6 - Remove the yellow battery pull tab protruding
from the replacement alarm.
7 - Install the replacement alarm on the replacement
mounting plate by turning clockwise. If installed
properly a green light labeled POWER should
illuminate on the front cover of the replacement alarm.
Push TEST button to confirm operation.
8 - Congratulations, you are done. Please direct your
questions to our help desk at 800-880-6788.
10000 Carbon Monoxide Alarm
EXISTING
MOUNTING
PLATE
EXISTING
POWER
HARNESS
WIRING ADAPTER
REPLACEMENT
ALARM
REPLACEMENT
MOUNTING
PLATE
EXISTING
POWER
HARNESS
FIREX
ALARM
EXISTING
POWER
HARNESS
BATTERY
PULL TAB
Advertisement
