Transducer; External Equipment - Furuno GP-1670F Installation Manual

3. WIRING
3.2

Transducer

Connect the transducer cable to the XDR port.
Transducer and sensor
Use the optional conversion cable (02S4147) to connect the optional speed/tempera-
ture sensor and the transducer to the XDR port. Refer to Operator's Manual in detail.
Matching box (option, required for 1 kW transducer)
The optional matching box (Type: MB-1100, Code No.: 000-041-353) is required to
connect the optional transducers 50B-6, 50B-6B, 200B-5S, 50/200-1T and 50/200-
12M.
Part
Matching Box*
Crimp-on Lug
Cord Lock**
*: With 10P connector cable
**: For connecting two transducers
Jumper block setting
Transducer
J2: No output reduction (default)
50B-6/6B
J1: Output reduction
50kHz
TB2
SHIELD
1
RED
2
RED
3
BLK
200kHz
4
BLK
5
Transducer
Detach grommet;
200B-5S
attach cord lock.
3.3

External Equipment

About CAN bus connections
CAN bus is a communication protocol that shares multiple data and signals through a
single backbone cable. You can simply connect any CAN bus devices onto the back-
bone cable to expand your network onboard. With CAN bus, IDs are assigned to all
the devices in the network, and the status of each sensor in the network can be de-
tected. All the CAN bus devices can be incorporated into the NMEA2000 network. For
detailed information about CAN bus wiring, see "Furuno CAN bus Network Design
Guide" (Type: TIE-00170) on Tech-Net), or contact your dealer.
3-2
Type
MB-1100
FV1.25-3 (LF)
NC-1
02P6348
J2 J1
TB1
WHT
3
2
1
BLK
Code no.
000-041-000
000-116-756-10
000-168-230-10
Vinyl Sheath
Green
(shield)
Connect 10P
connector to
Taping
XDR port on
rear of
display unit.
Qty
1
6
1
Crimp-on Lug
FV1.25-3 (LF)
Shield
Shrink Tubing