Table of Contents
Advertisement
4) Connect the GYRO CONVERTER Board to the INT Board (cables supplied
with GC-8) as shown below.
INT Board
J446 (4P)
J465 (6P)
5) Confirm gyrocompass specifications and set up the DIP switches and jumper
wires on the GYRO CONVERTER Board according to gyrocompass connected:
• Setting
jumper
specifications: page 4-3
• Setting
jumper
model of gyrocompass: page 4-5
• Location of jumper wires and DIP switches: page 4-6
6) Solder the gyrocompass cable to the VH connector assemblies (supplied).
7) Attach instruction label (supplied) to the shield cover for the INT and GYRO
CONVERTER boards.
8) Close the display unit.
9) Turn the power off and on to reset the CPU.
GYRO CONVERTER Board
J7 (5P)
J1 (14P)
J446
INT BOARD
03P9252
GYRO CONVERTER
BOARD 64P1106
Figure 4-2 Display unit, inside view
wires
and
wires
and
4-2
J5
To gyro
J4
J7
J1
Fix cable to chassis
with cable tie.
DIP
switches
DIP
switches
by
gyrocompass
by
make
and
Advertisement
Table of Contents
