Table of Contents
Advertisement
Cable fed from outside display unit
(A) Rear clamp base
Figure 2-10 Clamp position outside display unit
•
Place shielding foam between cables inside of display unit, and then attach
foam to chassis.
•
Fill unused clamp holes with shielding foam.
Cables fed from bottom of display unit (for console mount)
Lead in cables through the cable clamp at the rear of the console and ground their
shields in the cable clamp. For signal cable, remove vinyl sheath where cable lies
in cable clamp. Fasten cables with cable ties.
Close shutter door and cover
Close shutter and cover
it with aluminum tape to keep
with aluminum tape to
keep foreign objects out
foreign objects out of the
of the display unit.
display unit.
Figure 2-11 Clamp position at bottom of display unit
Shielding foam
M5x10 (2 pcs)
(Installation materials)
Rear cable entrance
(Display unit, right-hand side view)
Seventh hole
from the top
SIGNAL CABLE:
Remove the vinyl sheath here.
(1300 mm from display unit end
of cable remove sheath by 70 mm.)
2-7
(D) Rear clamp plate
(C) Signal clamp
(Aluminum)
(B) Power clamp
(Aluminum)
Bottom clamp front plate
(Installation materials)
Power Cable
(For display unit)
Log
Gyrocompass
Performance
NAV
Monitor
Slave Display
Power Cable
(For PM)
Cable Arrangement in the Console (Top view)
Signal Cable
ARPA
Advertisement
Table of Contents
