Image IMTL515040 User Manual page 9

8. Tighten the two 3/8" x 3 1/2" Bolts (81). Apply a Cap
Decal (113) to each Crossbar Cap (84).
9. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. Insert the pin into the Latch
Housing (75), and tighten the knob back onto the pin.
Raise the Frame (54) to a vertical position. While another
person holds the Frame, hold the Latch Housing (75)
against the inside of the Frame. Thread two 3/4" Screws
(6) several turns into the Latch Housing and the Frame.
Align the pin with the hole in the Left Handgrip (76) by
sliding the Latch Housing (75) up or down. Make sure
that the pin can be inserted fully into the hole. Hold
the Latch Housing in place and tighten the two 3/4"
Screws (6). Be careful not to overtighten the Screws.
Pull the knob to the right and carefully lower the Frame
(54) to the floor.
Note: After a period of use, the Latch Housing (75) may
need to be adjusted again to align the pin with the hole in
the Left Handgrip (76).
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 27). To protect the floor or carpet, place a mat under the treadmill.
8
9
9
84
81
113
Hole
76
Collar
Pin
75
54
Spring
6
Knob