Image IMTL11905.1 User Manual page 7

2. Attach the Latch Housing (89) to the Left Upright (90)
with two Latch Bolts (77). Do not overtighten the Latch
Bolts.
3. Have a second person hold the Handrails (114) near the
Right and Left Uprights (90, 95). Feed the Upright Wire
Harness (108) down into the Right Upright, and pull the
end of the Upright Wire Harness out of the lower end of
the Upright. Set the Handrail on the Uprights.
Finger tighten eight Upright Bolts (86) and four 3/8" Star
Washers (88) into the Uprights (90, 95) and the Handrail
(114) as shown. Do not tighten the Upright Bolts yet.
Be careful to avoid pinching the Upright Wire
Harness (108).
Note: The CD Holder (122) and the Cup Holder (123) are
replaceable. If these parts become dislodged from the
Console Base (80), simply press them back in.
4. Connect the Upright Wire Harness (108) to the Base
Wire Harness (115) in the bracket on the Base (99).
Make sure to connect the connectors properly (see
the inset drawing); the connectors should slide to-
gether easily and snap into place. If the connectors do
not slide together easily and snap into place, turn one
connector and try again to connect them. IF THE CON-
NECTORS ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
Insert the excess Upright Wire Harness (108) and Base
Wire Harness (115) up into the Right Upright (95).
2
89
77
3
122
86
114
90
4
7
90
80
123
88
86
88
114
95
108
99
108
115
86
95