Consumer Information Care • The pad is machine washable. Wash the pad separately in WARNING cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. • The frame, toy bar and toys may be wiped clean using a mild To prevent serious injury or death: cleaning solution and a damp cloth.
Page 3
IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price for replacement parts and instructions if needed. ® Never substitute parts.
Page 4
Assembly PRESS BUTTONS Back Crossbar Side Rails Screws • Insert a screw through the outside hole in each side rail and into • While pressing the buttons on the ends of the back crossbar, the ends of the front crossbar. insert into the ends of the side rails.
Page 5
Assembly Kickstand • Fit the kickstand onto the assembly, as shown. • Fit the pad pocket onto the seat back tube. Waist Belts Screws Screws • Insert four screws into the kickstand and tighten. BACK VIEW • Insert the waist belts through slots in the back of the pad. •...
Assembly Battery Installation Hint: We recommend using an alkaline battery for longer battery life. 1,5V “D” (LR20) • Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities (Europe only). Pad Buckles •...
Setup and Use Infant - Recline WARNING To prevent serious injury or death: • Fall Hazard - Never use this product on an elevated surface, since child’s movement may cause the product to slide or tip over. Use BACK VIEW only on a floor.
Page 8
Infant - Recline Toddler - Upright Anchored End Anchored End BACK VIEW Free End Free End Seat Position TIGHTEN LOOSEN • Fasten the straps on the back of the pad for the Toddler-Upright Position. To tighten the belts: • Feed the anchored end of the restraint belt up through the buckle to form a loop .