Traxxas XO-1 64077 Owner's Manual page 27

Front Differential Removal
3. 3x15 BCS
5. 3x15 BCS
4. 3x15 BCS
5. Remove the two 3x15mm button head screws from the
differential cover and set the differential cover aside.
6. Remove the two screw pins that fasten the driveshafts to the
differential output.
7. Installation is the reverse of above.
Rear differential:
1. Remove the two 3x25mm countersunk screws from the
underside of the chassis.
2. Remove the two 3x15mm button head screws from the
differential case, set the splitter/rear body mount assembly aside.
3. Remove the 3x15mm button head screw from the rear tie bar
and set aside.
Rear Differential Removal
4. 3x15 BCS
2. 3x15 BCS
5.
3. 3x15 BCS
4. Remove the two 3x15mm button head screws from the
differential cover and set the differential cover aside.
5. Remove the two screw pins that fasten the driveshafts to the
differential output.
6. Installation is the reverse of above.
Refilling the differential:
6.
1. Remove the four 2.5x12mm screws
from the differential case and
carefully pull the differential case
halves apart. Work over a towel to
1. 4x15 CCS
collect any fluid that drips from the
2. 4x30 CCS
differential.
2. Drain the fluid from the differential.
You may wish to remove the spider
gears from the differential to make
this easier.
3. Place the spider gears back into the
differential case, if you removed them. Fill the differential case
with fluid until it the spider gears are submerged half way.
4. Rejoin the differential case halves, using care to align the screw
holes. Be sure the rubber gasket is in place, or the differential
may leak.
5. Install the 2.5x12mm screws and tighten securely.
1-888-TRAXXAS
1. 3x25 CCS
ADVANCED TUNING ADJUSTMENTS
If you have questions or need technical assistance, call Traxxas at
(1-888-872-9927) (U.S. residents only)
XO-1 27
•