Traxxas XO-1 64077 Owner's Manual page 14

The following Traxxas High
Current Connector packages
are available from your
hobby dealer. When using
adapters, be careful not to
exceed the current rating of
the Molex connector.
Part #3060 Part #3080
Single Male/Female 2-Pack Female
Part #3061 Part #3070
Male Charge Adapter
2-Pack Male
Part #3062
Female Charge Adapter
Battery Compartment Specs:
• 49.5mm (1.95") wide x
155mm (6.10") long (stock)
or 135mm (5.31") long
• Height with stock strap:
23mm (.91") or 25mm (.94")
Note: There is some flex with
the battery strap. It is possible
to fit slightly taller batteries in
the compartment.
4
14 XO-1
•
TRAXXAS TQ RADIO SYSTEM
i
INSTALLING & REMOVING THE BATTERY PACKS
The XO-1's battery
compartments can
accommodate a variety of LiPo
battery configurations. From
the factory, the compartments
are set up for Traxxas Power
Cell 5000mAh 3S packs. The
number on each side of the
hold-down indicates the
battery height in millimeters
that the hold-down can
accommodate. Note that one
side is labeled "23mm/38mm"
and other side is labeled
"25mm/40mm".
Always remove the batteries from the model before recharging.
Battery Compartment Height Chart
The chart below show the heights available through
various hold-down and retainer combinations. Parts in
bold are sold separately.
Height (mm) Hold-Down Part Number Retainer Part Number
20 #6426X
23 #6426
25 #6426
28 #6426X
35 #6426X
38 #6426
40 #6426
#6426X
43
Removing the Battery Packs
1. Unplug the High Current Connectors.
2. Flex the retainer away from the center of the chassis.
3. Lift up the battery hold-down, and pull it away from the chassis.
4. Repeat for the opposite battery.
Installing the Battery Packs
1. Insert the battery into the tray with the High Current Connector
positioned towards the rear of the car.
2. Insert the hold-down into the lower set of holes in the center
support. If you are installing Traxxas Power Cell 5000mAh 3S
batteries, the hold-downs should be oriented so the side labeled
"25mm/40mm" is facing up.
3. Align the hold-down over the retainer and press down until it
snaps into place.
4. Repeat for the opposite battery.
5. When you are ready to drive, connect the High Current
Connectors to the speed control.
Adjusting The Battery Compartment Length
The XO-1's battery compartments
are configured for batteries that are
155mm long. The compartments'
rear battery cup can be moved
forward 20mm to accommodate
135mm battery packs. To configure
the compartments for 135mm packs,
remove the 3x10mm countersunk
screws, and reinstall the battery cup
using these screws in the rear set of
holes in the battery cup.
#6427
#6427
#6427
The Traxxas High Current Connector
#6427
#6427X
#6427X
#6427X
#6427X
The Traxxas connector's gold-plated terminals with a large contact
surfaces ensure positive current flow with the least amount of
resistance. Secure, long-lasting, and easy to grip, the Traxxas
connector is engineered to extract all the power your battery
has to give.
Your model is equipped with the patented
Traxxas High-Current Connector. Standard
connectors restrict current flow and
are not capable of delivering the power
needed to maximize the output of brushless
power systems.