Wash Basket - GE Profile WPGT9150 Technical Service Manual

3. Disconnect the pressure sensor hose from the
outer tub.
Disconnect
4. The main wiring harness is held in place by
plastic clips on the inside corner of the washer
cavity. Remove the wiring harness from the
holding clips.
5. Remove the screw that holds the ground wire to
the upper back cover.
6. Disconnect the four wiring harness connectors.
Disconnect
7. Lift the back of the top cover and slide it forward
to clear the front tabs.
Disconnect
Disconnect
Disconnect

Wash Basket

Caution: If the basket is not free to rotate, damage
to the clutch coupler can occur. Ensure that the
washer is in the spin mode before removing the
wash basket. The wash basket will rotate freely
when it is in spin mode. Do not attempt to remove
the hub nut if the basket is not free to rotate.
To remove the wash basket:
1. Remove the top cover. (See
2. Remove the 8 Phillips-head screws that hold the
outer tub cover in place.
3. Place a fl at blade screwdriver in the slot under
the infusor cap and gently pry off.
Infusor Cap
Infusor
– 21 –
.)
Top Cover
Slot
(Continued Next Page)