INSTALL SEAT (See Figs. 2 and 3)
•
Remove bolt and flat washer se cur ing seat to cardboard
packing and set aside for as sem bly of seat to tractor.
Remove the cardboard packing and discard.
•
Connect switch to seat.
•
Place seat on seat pan so all three (3) bottom pads
are positioned over large slotted holes in pan.
SEAT
SWITCH
PAD
SLOT
SEAT
PAN
•
Push down on seat to engage pads in slots and pull
seat towards rear of tractor.
•
Raise seat and tighten bolt securely.
•
Remove tape and discard.
•
Lower seat into operating position and sit on seat.
Press clutch/brake pedal all the way down. If operating
position is not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle and pull up, slide
seat to desired po si tion and release adjustment handle.
SLOT
PAD
FLAT
WASHER
SEAT PAN
BOLT
TAB
CHECK BATTERY (See Fig. 4)
•
Lift seat pan to raised position.
•
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in MAINTENANCE section of this
manual for charging instructions).
ASSEMBLY
WIRING HARNESS
Fig. 2
ADJUSTMENT
HANDLE
Fig. 3
SEAT PAN
TERMINAL
NOTE: You may now roll or drive your tractor off the skid.
Follow the ap pro pri ate instruction below to remove the
tractor from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
TAPE
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op-
er a tion section for location and function of
con trols)
•
Press lift lever plunger and raise at tach ment lift lever
to its highest po si tion.
•
Release parking brake by depressing clutch/brake
ped al.
•
Place gearshift lever in neutral (N) po si tion.
•
Roll tractor forward off skid.
•
Remove banding holding the de flec tor shield up against
tractor.
TO DRIVE TRACTOR OFF SKID (See Op-
TAPE
er a tion section for location and func tion of
con trols)
•
Be sure all the above assembly steps have been com-
plet ed.
•
Check engine oil level and fill fuel tank with gasoline.
•
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
•
Place gear shift lever in neutral (N) position.
•
Press lift lever plunger and raise at tach ment lift lever
to its highest position.
•
Remove key from bag and start the engine (see "TO
START ENGINE" in the Operation section of this
manual). After engine has started, move throttle control
to idle (slow) position.
•
Depress clutch/brake pedal into full "BRAKE" position
and hold. Move gearshift lever to 1st gear.
•
Slowly release clutch/brake pedal and slowly drive
tractor off skid.
•
Apply brake to stop tractor, set parking brake and place
gearshift lever in neutral position.
•
Turn ignition key to "STOP" position.
Continue with the instructions that follow.
7
LABEL
TERMINAL
FIG. 4