GE Profile PSF26PGWBB Technical Service Manual page 26

9. Lift the fan housing up, pull it forward, and
disconnect the wire harness.
10. Remove the two ¼-in. hex-head screws that
attach each mounting bracket.
11. Slide the air tunnel upward to remove.
Note: Failure to replace the air tunnel will affect
temperature performance.
12. Remove the three T-20 torx screws that attach
each drawer track to the left wall of the freezer.
13. Remove the light bulb cover and light bulbs.
Wire Harness
(Continued next page)
– 26 –
14. Unclip the light bulb sockets from their mounting
holes and disconnect the sockets.
Note: The evaporator cover is held in place by four
¼-in. hex-head screws and 2 top tabs. The tabs are
inserted into recessed slots in the bottom of the
evaporator fan plenum.
15. Remove the 4 hex-head screws that hold the
freezer evaporator cover in place.
16. Lift the cover up to clear the front lip of the drain
trough, then lower the cover to release it from
the 2 recessed slots.
17. Pull the left side of the cover out and rotate the
harness grommet clockwise to release it from
the cover.
18. Carefully remove the cover from the freezer.
Fan Plenum
Top tabs
Harness Grommet
(Continued next page)