Connecting The Drain Hose; Connecting To The Power Supply - Kenmore 796.4128 Series Use & Care Manual

Kenmore front-loading automatic washer
Hide thumbs Also See for 796.4128 Series:
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION INSTRUCTIONS

CONNECTING THE DRAIN HOSE

• The drain hose should always be properly secured.
Failure to properly secure the drain hose can result in
fl ooding and property damage.
• Do not install the end of the drain hose higher than 96
in. (243.8 cm) above the bottom of the washer.
• The drain must be installed in accordance with any
applicable local codes and regulations.
• Make sure that the drain hose is not stretched, pinched,
crushed, or kinked.
NOTE:
A drain hose extension kit is
available if the drain hose is not
long enough. Do not extend the
drain hose more than 6 feet, as
this will cause poor draining,
which will result in poor wash
and spin performance.
Option 1: Standpipe
Install the end of the drain hose into the elbow bracket.
Do not extend the drain hose more than 4 inches past the
end of the elbow bracket. Use a tie strap to secure the
drain hose in place.
NOTE:
• Total height of the hose end should not exceed 96 in.
(243.8 cm) from the bottom of the washer.
• The drain hose should be inserted no more than 8–12
inches into the standpipe. Inserting more than 8-12
inches can cause mold or microorganisms to spread to
the inside of the washer.
If the water valves and drain are built
into the wall, fasten the drain hose
to one of the water hoses with the tie
strap (ribbed side on inside).
Drain Hose Extension
P/N 5215ER2002K
Elbow Bracket
Tie Strap
Drain Hose
Tie Strap
10
Option 2: Laundry Tub
The elbow bracket should be installed near the end of
the drain hose. Hang the end of the drain hose over the
side of the utility sink. Use a tie strap to secure the drain
hose in place.
Option 3: Floor Drain
Drain Hose
Floor Drain
Insert the end of the drain hose into the fl oor drain.
If possible, secure the hose to prevent it from moving or
coming out of the drain.

CONNECTING TO THE POWER SUPPLY

Washer should be plugged into a 120-VAC, 60-Hz
grounded 3-prong outlet. Plug in the washer.
Utility Sink
Elbow
Bracket
Tie Strap
Drain Hose

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents