Adapting Blower For Outside Back Exhaust; Mount The Microwave Oven - GE JVM1630 Installation Instructions Manual

C4 ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST (cont.)
Gently place the fan back into the cavity with the
6
exhaust portion of the fan at the top and facing the
back of the unit.
Note: Make sure the wires remain routed through
the openings in the motor frame. To avoid damage
to the fan motor wiring, insert motor carefully such
that the fan motor wiring does not contact the
microwave power cord bracket.
7 Replace screw on the back of the unit.
Slide the vent damper on back of the unit with the
8
hinge at the top.
Slide
exhaust
adaptor into
guides on
microwave
oven rear.
Replace the vent cover on the unit and secure it
9
to the unit by replacing the two screws that were
removed, with one in the middle hole and one on
either side.
Side Tab
Side Slot
Installation Instructions
Screw
Damper
(hinge side up)
Exhaust
Adaptor
Locking Back of
Tabs Microwave
Oven
Rear
Tab
Rear Slot
C5

MOUNT THE MICROWAVE OVEN

CAUTION:
injury (back injury or other injuries due to excessive
weight of the microwave) or property damage, you
will need two people to install this microwave.
IMPORTANT: Do not grip or use handle during
installation.
WARNING:
cause injury or death: If installing unit with metal
countertops, cover the edge of the power supply
cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE: When mounting the microwave, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
microwave oven by pulling cord.
1 Lift microwave, tilt it forward, and hook slots at
back bottom edge onto four lower tabs of mounting
plate.
Power Cord
Rotate front of microwave oven up against cabinet
2
bottom.
22
To avoid the risk of personal
Risk of Electric Shock. Can